Problems to be noted in the operation procedure. In the use of the process of some of the need to pay attention to the place, master these methods can effectively protect and extend the life of the test machine itself, but also has important significance in the security work. The following problems are some of the problems that need to be noticed in the process of using the torsion test machine:
1 counters in the setting of the initial value of the time should be in the case of power, otherwise the counter will only remember the first set of the initial data.
2 there is also the counter in the initial set of time to pay attention to the ratio of the set, the general situation of the selected rate should be "X1" file.
3 if in the process of transportation, responsible for counting the signal input of the dry reed relay damage resulting in no count, can put the reducer on the cover off, with spare dry reed relay to replace the damaged.
4 speed gear adjustment to open the door and left side reducer operating table cover door, according to the actual application to operate.
5 in the first use of the installation of the test machine in the process of the need to test machine on the ground screw tightening, so that the instrument can ensure the level of good.
6 in the process of adjusting the speed profile must cut off the power, so as to avoid unsafe accidents.
7 usually to pay attention to the maintenance of the instrument, after each test, the test machine should be around to clean up the environment, so that the instrument can ensure good performance and the use of results.